How To Replace the Floor Inside an RV Slide Out?
While new RVs come with nice looking brand new flooring, it wears out time. Too much use and low quality of the flooring are the commons reasons why wear our hence requiring a replacement. Additionally, one might wish to try a different flooring on their RV, thanks to a variety of modern-looking flooring.
Notably, the installation of flooring in an RV slide out is as easy as installing the flooring in other parts of the RV. The following are crucial tips to consider while replacing the flooring inside an RV slide out.
Removing the Old RV Slide out Flooring
The first step in replacing your flooring in any area of your RV is removing the old flooring. Notably, the utility knife, scissors, the miniature crowbar, and pliers are essential tools in the removal of the old flooring. The miniature crowbar relatively eases the removal of the tiles in the RV’s slide out.
One should wear gloves during the removal process as a precaution measure. The removal of the carpet might take time too just like the removal of tiles. This follows the fact that many staples bind the carpet and the carpet together, which need to be removed.
Video Overview: How to Prevent a Wet RV Slide Out Floor – UPDATED
> You may also like:Worst 5th Wheel Brands to Avoid <<
Preparing the Subfloor
After the removal of the tiles and the carpet, the subfloor might have been left imperfect for the installation of new flooring. You might need to ensure that all the staples from the wood flooring are got rid of as the first step in the preparation of the subfloor.
Some of the floorings might require to be repaired before the installation of the new flooring. Leveling and smoothening the subfloor needs to be done to ensure the subfloor is without imperfections. Notably, one can use the wood filler into the damaged areas with a putty knife, leaving it to dry and later sanding it smooth.
Video0 Overview: Slide Out Floor Replacement Part 1
Preparing the Underlayment
Preparing the underlayment comes with cutting it using the utility knife or a square. When preparing the underlayment, one must measure and marks the wheel well’s positions.
Additionally, when cutting the wheel wells squares, use your drill to create holes, then use the jigsaw to cut along the lines. The underlayment is finally put down for the installation of the flooring in the slide-out.
> You may also like: 25 Best National Parks in the USA <<
Installation of the Flooring in the Slide Out
The last tip on replacing the floor inside an RV’s slide-out is the installation of the flooring. With the flooring well-cut, installing it in the slide-out is achievable.
Notably, you might need to install a level subfloor if your RV’s slide has rollers that leave it uneven. Additionally, attaching the trim along the edges is one of the best ways to finish the edge of your slide out.
Video Overview: How Do You Replace Flooring Under the Slide Out of an RV? (Life Hack Tip in a Minute)
Replacing the flooring inside the slide out of your RV is not much different from replacing the flooring of other parts of your RV. The process involves the removal of the old flooring, the preparation of the subfloor and underlayment, with the installation of the flooring being the final step. Following several tips, as stated above, might have you a perfectly replaced flooring inside your RV’s slide out.
> You may also like:45 RV Accessory Must-Haves for Your Travel Trailer<<